Automotive
Includes ABS components, electronics, connectors, instruments, and sensors.
Product Name: Male Terminal
Application: Automotive electrical harness connector part.
Description: A precision terminal with a 1/4 inch wide knurl designed to be pressed into a thermoset insulator. Terminal head has a .06 inch detent for positive locking with a female mating connector part.
Dimensions: 0.156 inch diameter shaft by 0.796 inch length.
Material: 7/32 inch diameter Soft Yellow Brass
Tolerances: ± .005 inch with some critical dimensions held to .002 inch
Finishes: None
Fabrication: Single spindle Swiss screw machine.
Special Features: Knurl designed to lock terminal in place under vibration. No burrs allowed anywhere.
Product Name: Tapped Terminal
Application: Automotive Cable Harness Connector.
Description: A terminal with a hollow shaft tapped with 6-32 threads. The smaller diameter portion of the shaft is knurled and has a .093 inch diameter hole. The knurled end of the terminal is designed to press fit into a thermoset insulator so the part won't rotate. The hollow portion can then be rolled over or flared to provide rivet like retention.
Dimensions: 7/32 inch diameter shaft by .634 inch length and .753 inch length.
Material: 7/32 inch diameter soft yellow brass
Tolerances: 0.005 inch with some dimensions held to 0.004 inch.
Finishes: None.
Fabrication: Single spindle Swiss screw machine.
Special Features: No burrs or sharp edges allowed.
Product Name: Compass Lubber Line
Application: Marine Compass Component.
Description: A miniature shaft with two knurls designed to function as an indicator to reference compass heading.
Dimensions: 0.045 inch diameter made in three lengths for different compass models. The lengths manufactured are 0.625 inch, 0.800 inch, and 1.500 inch.
Material: Free turning brass drill rod
Tolerances: ± .005 inch with shaft dimensions held to ± .0005 inch
Finishes: Bright dipped and etched.
Fabrication: Single spindle Swiss screw machine.
Special Features: No burrs or sharp edges allowed.
Product Name: Pointer Post
Application: Parts are used in a switch gauge or micro-controller holding and turning the pointing indicator (needle on a gauge).
Description: A small cylindrical part with multiple cut diameters. Shown next to a one inch scale for size comparison.
Dimensions: 0.885 inch length with a 0.118 inch maximum diameter.
Material: Brass CDA 360.
Tolerances: ± 0.005 inch with some critical dimensions held to ± 0.0005 inch.
Finishes: No special finish.
Fabrication: Coil fed automatic Swiss.
Special Features: Corners at ends have a 0.002/0.005 radii to aid in assembly.
